The installed version of PSPICE includes only some basic components of electronics, like resistors, power supplies and ground.
#Pspice schematics 9.1 citation how to
In last tutorial ,we have seen how to download and install PSpice software. Explanation of using the basic components along with their uses in circuit development is explained. I will explain the use of PSPICE schematic including how to create a project how to use basic components that are need to design the very basic electrical circuit, and how to add libraries in the components part. Make sure that in the Library Path there is a correct path to the PSpice main library (see the picture above as an example of a proper path).Ī) Wrt the error you mentioned "ERROR(ORPSIM-15108): Subcircuit LM741/NS used by X_U5 is undefined", this is caused by improper setting of PSpice simulation profile (either improper path to the Model.lib or main Library Path).ī) Overall, the trick is that import of a PSpice model is done twice: once in Orcad Capture and once in PSpice (would have been better if done automatically by the program).Ĭ) Of course, to add the component in Capture, one needs to add the library (Model.olb) in a Place Part subwindow.ĭ) Not sure, but likely names of the files Model.lib and Model.olb must be the same, so that PSpice knows what Spice model to use.In this tutorial I will explain how to use PSPICE to design a circuit for the first time.Make sure that the file \tools\pspice\library\nom.lib is also added to the Configured Files as a Global.Enter the path to Model.lib in the Filename field -> Press Add to Design button.tran1) -> In an opened window go to "Configuration files" tab -> Library category Open Orcad Capture, PSpice -> New Simulation Profile -> Enter any name for the profile (e.g.This is done, because PSpice works only with. Rename the file from Model.mod to Model.lib.opjĬ) Field Schematic Configuration File: leave it as suggested Open Orcad Capture -> File -> Import -> PSpice -> OKī) Field Save as: path to an Orcad library to be created with a new component.Creation of Orcad's component library (.olb file) Secondly, the model must be properly "fed" to PSpice.
#Pspice schematics 9.1 citation simulator
The answer below is how to properly import a PSpice model (usually generated in a third-party software) into Orcad Capture and PSpice so that both the schematic editor and the simulator work without errors.įirstly, the model must be imported into Orcad Capture (so that a new component and a new library.